Phone Firmware - Viking 40-IP Product Manual

24. Mute Current / Next Alarm
A network failure alarm will be indicated by providing 3 beeps every 30 seconds. A network failure indicates the unit is
not registered to the SIP server or there is a communication failure with the gateway. The three beeps can be muted by
clicking on "Mute Current / Next Alarm". The Status LED will continue to flash to assist troubleshooting. The alarm beeps
can also be permanently disabled. See Permanent Alarm Mute.
25. Permanent Alarm Mute
Selecting "Alarm Tones Disabled" will mute all alarm tones indefinitely. To re-enable alarm tones select "Alarm Tones
Enabled".
26. Programming Username and Password
To increase security a username and password can be programmed. With the username and password programmed
you will be required to enter both the username and password each time you connect to that unit for programming.
27. IP Firmware
If new 40-IP firmware is available, after opening the programming software a pop window will come up asking you if
you would like to update firmware. An alternative method of updating can be done by clicking the IP firmware "Update"
button. You can then browse to the folder that contains the PIP file for updating the unit's IP firmware. This method is
typically only used when Viking Technical Support has sent you updated IP firmware

28. Phone Firmware

If new 40-IP firmware is available, after opening the programming software a pop up window will ask if you would like
to update firmware. Another way to update is accomplished by clicking the phone firmware "Update" button. You can
then browse to the folder that contains the HEX file for updating the unit's firmware. This method is typically only used
when Viking Technical Support has sent you updated firmware.
15