Operation Mode "Hand - Gako Unguator e/s Operating Instructions Manual

To remove the UNGUATOR
®
The UNGUATOR Mixing System is then removed from the bayonet receptor by twisting
the UNGUATOR ® MB shaft counterclockwise. Then the UNGUATOR
can be removed by pulling it downwards.
3.2 Operating Mode "HAND"
The pre-prepared UNGUATOR
of the UNGUATOR
®
UNGUATOR Jar Lid and the UNGUATOR
hand simultaneously.
The bayonet receptor will grip immediately when the UNGUATOR
using the "Start/Stop" button. It will now run from the first revolution until the mixing
process is complete. The programmed mixing time will be completed at the set speed
step. The mixing time and speed parameters can also be changed during the mixing
process.
We recommend moving the UNGUATOR
the UNGUATOR ® Jar bottom to the stop on the UNGUATOR
while holding the UNGUATOR
®
The UNGUATOR Mixing System can be switched to freespin as a special step with
manual stroke movement. Press the "Start/Stop" before the mixing process is complete
to switch to freespin. This will interrupt the mixing process, and the display will prompt
for freespin by showing "FSPA".
The UNGUATOR ® Mixing System needs to be removed from the UNGUATOR
and the UNGUATOR
®
UNGUATOR Jar bottom is then pushed into the full down position using the
®
UNGUATOR MB. Then the UNGUATOR
®
ATOR Mixing System should now be inserted back into the bayonet receptor of the
®
UNGUATOR e/s from below and pushed up as far as it will go. Now push the "Start/
Stop" button again, and the UNGUATOR
speed rotation in a position close to the lid. This is referred to as freespin. Most of the
ointment is removed from the UNGUATOR
The display will show the total mixing time incl. the reset times after the freespin is
finished.
The mixing process using the UNGUATOR
®
Mixing System, first screw off the UNGUATOR
®
Mixing System is inserted into the bayonet receptor
®
e/s from below and pushed up as far as it will go. The
® Mixing System tightly with at least one hand.
®
Jar Lid slightly untwisted as if for air diminuation. The
®
®
Jar housing should both be held in one
®
Jar up and down steadily from the stop on
®
Jar Lid is retightened. The UNGU-
MB can now clean itself by means of high-
®
MB and the mixing process is complete.
®
e/s
®
Jar Lid.
® Mixing System
® e/s is switched on
® Jar Lid every second,
® e/s
29