E/S Error Messages - Gako Unguator e/s Operating Instructions Manual

Fault Fault remedy
display
FE 0 Hit the "Start/Stop" button,
oscillation arm moves to
the next end position
FE 1 Remove jar and
hit the "Start/Stop" button,
Oscillation arm moves to
the desired position
FE 2 Hit the "Start/Stop" button,
FE 0 displays
FE 8 Hit the "Start/Stop" button,
snap in jar - reboot
FE 9 Oscillation arm will automatically
return to home position
FE 9 Remove jar and
hit the "Start/Stop" button
FE A Hit the "Start/Stop" button,
possibly switch off device
Table 3-5: UNGUATOR
Error messages will also occur if UNGUATOR
respective size of the UNGUATOR
process has been left at the beginning of the mixing process rather than the start
position required for the new mixing process.
Incorrect operation or environmental influences may cause problems not listed in the
error list. If this occurs, switch off the device or pull the power plug. The UNGUATOR
may then be switched on again after period of 10 seconds.
32
®

e/s error messages

® Jar or if the end position of the previous mixing
The mixing process using the UNGUATOR
Possible causes of fault
Switching the device on and off during
a work phase or temporary blackout
change-over between the operating modes,
when a mixing unit has locked in place
or switching on the device when a mixing
mixing unit has locked in place
Oscillation arm does not move or very
slowly
No mixing unit locked in place when in
"HAND" mode
No mixing unit attached to oscillation arm
in "AUTO" mode
No mixing unit snapped in or released
in "AUTO" mode
Temporary motor overload
® MBs are used that do not match the
®
e/s
®
e/s