Preparing The Mixing Process; The Mixing Process; After The Mixing Process Is Complete - Gako Unguator e/s Operating Instructions Manual

2.3 Preparing the Mixing Process

Together with the UNGUATOR
screwed onto the UNGUATOR
been weighed in. By pushing up the UNGUATOR
®
large UNGUATOR Jars, with the UNGUATOR
the air will escape between the UNGUATOR
Then the UNGUATOR
is called air diminuation.
Air diminution will not only prevent ointment exudation at the sealing zones of the
®
UNGUATOR Jar through reduction of any overpressure that may have developed.
The mixing result is also optimized since there is no trapped air. We recommend,
mainly in the case of intermingling large quantities of powder, that air diminuation be
repeated after 15 seconds of the mixing process.
When pregrinding by pasting the solids with some foundation in the UNGUATOR
we recommend positioning the movable UNGUATOR
possible. This will guarantee that the large surface area of the inside wall of the
®
UNGUATOR Jar also including the lid and bottom can be used for dispersion between
the friction surfaces of the UNGUATOR
UNGUATOR ® Jar housing. Consequently, no air diminuation need be carried out before
pegrinding.
At this point of the mixing process, device-specific settings will need to be implemented
and the UNGUATOR
are exhaustively described in chapter 3.

2.4 The Mixing Process

Extending the mixing time and increasing the speed of the mixing motor will improve
the product quality of the ointment. Please see chapter 3 for more detailed information
and device-specific settings.
General guidelines for the UNGUATOR
®
Jar Lid, the UNGUATOR
®
Jar housing after the formulation constituents have
® Mixing System should be tightly screwed down. This process
®
Mixing System connected to the UNGUATOR
®
®
Jar bottom with a thumb or, for
®
Spindle or the AirDynamic® System,
® Jar Lid and the UNGUATOR
®
Jar Bottom as far downward as
® MB and the inside surface area of the
®
Mixing System
MB should be loosely
® Jar housing.
®
Jar,
®
. These procedures
25