Notes On Dispensing Ointment - Gako Unguator e/s Operating Instructions Manual

The air was not diminuated from the UNGUATOR
centrifuges the ointment against the UNGUATOR
inside in which the UNGUATOR
may adhere to the UNGUATOR
The UNGUATOR
®
ATOR MB will generate an overpressure at high rate of speed that cannot be
compensated when the movable bottom yields. Thus the overpressure may cause
mixed material, mainly liquid constituents, to squeeze out of the seals on the threaded
UNGUATOR ® Jar Lid, between UNGUATOR
and along the shaft of the UNGUATOR
The sealing lip on the UNGUATOR
emulsifying process. Before starting the mixing process, particularly for large amounts
of liquids, the region round the sealing lip of the UNGUATOR
carefully brushed with foundation so as to improve its sealing quality.
The sealing lip of the UNGUATOR
®
UNGUATOR MB upon perforating the lid. This will cause ointment to creep up the
shaft.
The UNGUATOR
guided stroke. This may cause the UNGUATOR
process, resulting in a large mess.
The user failed to diminuate air again or to mount a UNGUATOR
®
UNGUATOR applicator before dispensing. This will cause the user to first push the
air out of the opening and the ointment will follow in a gush [1].

4.3 Notes on Dispensing Ointment

Each customer should be given specific dispensing instruction when being given
ointment in an UNGUATOR
explained for large UNGUATOR
®
UNGUATOR Applicator or an UNGUATOR
volume. Medium-viscous ointments can be easily emptied through the small opening
of the UNGUATOR
through this opening, even using the spindle.
36
® MB cannot clean itself and unmixed constituents
®
MB.
®
Jar bottom has not been moved up. The penetrating UNGU-
®
®
Jar Lid is damaged by the shaft tappets of the
®
Jar Lid is not tightened correctly and not held during the manually
® Jar. The use of the UNGUATOR
® Jars. Low-viscous ointments should be fitted with an
®
Jar. Principle-related, very pasty ointments cannot be pressed
General notes on the UNGUATOR
®
Jar. Then the mixing blade
® Jar wall, forming an air column
® Jar bottom and UNGUATOR
®
MB [1].
Jar bottom does not retain liquids during the
® Jar Lid to untwist during the mixing
®
varionozzle to reduce the dispensed
® Jar housing
®
Jar bottom should be
®
Varionozzle or
® Spindle should be
®
Mixing System