Table of Contents
Advertisement
1.
Important information for the installation of the DVD system
These installation instructions are primarily designed for use within the BMW dealership
organisation and by authorised BMW service companies.
In any event the target group for these installation instructions is specialist personnel trained on
BMW cars with the appropriate specialist knowledge.
All work must be completed using the latest BMW repair manuals, circuit diagrams, servicing
manuals and work instructions in a rational order using the prescribed tools (special tools) and
observing current health and safety regulations.
Ensure that the cables/lines are not kinked or damaged as you install them in the car. The costs
incurred as a result of this will not be reimbursed by the BMW AG.
Additional cables/lines that you install must be secured with cable ties.
If the specified PIN chambers are occupied, bridges, double crimps or twin-lead terminals must
be used.
All the figures show LHD cars, proceed in exactly the same way on RHD cars.
Inform the car owner that the DVD system has a separate fuse. The fuse holder is located
at the rear left of the boot in the vicinity of the retrofit plug connector X322 . Check the fuse
first if the DVD system does not work. If it has blown, it must be replaced by a new 3 A
fuse .
If the car has an alarm system, inform the owner that optimum function of the alarm system
can only be guaranteed when the DVD monitor is folded in.
Depending on the equipment in the car, 2 part numbers (installation kit and DVD
system) must be ordered using the electronic parts catalogue (EPC) for the installation of
the DVD system.
All holes drilled must be treated with anti-corrosion measures set out in BMW
specifications.
Subject to technical modifications
Required tools and equipment
MoDiC III or DIS
1/4 inch socket set
Set of Torx sockets
Set of Philips screwdrivers
Set of flat screwdrivers
Set of drill bits
Conical counter-sink
Drill
Retrofit / Installation kit No. 82 82 0 304 134 (others see cover sheet)
Installation Instructions No. 01 29 0 141 494
Cable lamp
Angle cutter
Universal knife
Textile adhesive tape
Dust extractor
Threaded rivet pliers
Disconnection tool
Issue date: 05.2003
EN/3
Advertisement
Table of Contents
