Table of Contents
Advertisement
7 .
To retrofit an earth connector (only required if there is no earth post X10305
below the left tail light)
0
!
0
!
!
Retrofit / Installation kit No. 82 82 0 304 134 (others see cover sheet)
Installation Instructions No. 01 29 0 141 494
!
=
>
!
039 0235 B
#
#
"
!
039 0236 B
Issue date: 05.2003
0
Only cars up to production date 9/00
Risk of damage. Before drilling the hole
ensure that the cable and plug fastenings are
unclipped and the cables are removed from
the drilling area to prevent their being
damaged.
Centrepunch the position of the hole (30).
Dimension a = 22 mm
Dimension b = 17 mm
Remove the paint and primer in the grey area (31)
over a diameter of 20 mm around the position of
the hole (20) on the front and rear of the tail light
unit (32).
Remove the area (31) in a diameter of 20 mm
around the position of the hole (20) on the front and
rear of the tail light unit (32).
The panel must be bare in the grey area (31), to
ensure that perfect contact is possible.
Drill the hole with a 6 mm drill bit and vacuum up
any chips and swarf.
Then deburr the edges of the hole.
Only cars up to production date 9/00
0
Insert the hexagonal screw with collar (13) from the
rear into the hole (30) drilled previously and secure
it with a nut M6 (15).
If installing an earth connection cable (31)
subsequently, make sure that the bodywork
washer (14) is fitted first, then the cable lug of the
earth connection cable (31).
Then screw on the earth connection cable (31)
with the second nut M6 (15) (the earth connection
cable (31) must point towards the centre of the
car).
After securing the parts, treat all of them with
the anti-corrosion measures set out in the
BMW standard.
EN/13
Advertisement
Table of Contents
