Table of Contents
Advertisement
7 .
To retrofit an earth connector (only required if there is no earth post X10305 below the left
tail light)
0
!
>
=
0
32
0
30
13
Retrofit / Installation kit No. 82 82 0 304 134 (others see cover sheet)
Installation Instructions No. 01 29 0 141 494
!
039 0238 B
b
a
31
30
039 0239 B
15
14
15
31
039 0240 B
Issue date: 05.2003
0
Only cars up to production date 9/00
The figure shows the lamp holder of the left
tail light.
Mark the drilling position (30) on the left lamp
holder (31) with dimension a and b, then use a step
drill bit to drill the hole out to a diameter of 18 mm.
Dimension a = 17 mm
Dimension b = 11 mm
Then deburr the hole and install the left tail light
and the left lamp holder (31).
0
Only cars after production date 9/00
Risk of damage. Before drilling the hole
ensure that the cable and plug fastenings are
unclipped and the cables are removed from
the drilling area to prevent their being
damaged.
Centrepunch the position of the hole (30).
Dimension a = 19 mm
Dimension b = 17 mm
Remove the body paint and primer from the grey
area (31) in a diameter of 20 mm around the
position of the hole (30) on the front and rear of the
tail light unit (32).
The panel must be bare in the grey area (31), to
ensure that perfect contact is possible.
Drill the hole with a 6 mm drill bit and vacuum up
any chips and swarf.
Then deburr the edges of the hole.
0
Only cars after production date 9/00
Insert the hexagonal screw with collar (13) from the
rear into the hole (30) drilled previously and secure
it with a nut M6 (15).
If installing an earth connection cable (31)
subsequently, make sure that the bodywork
washer (14) is fitted first, then the cable lug of the
earth connection cable (31).
Then screw on the earth connection cable (31)
with the second nut M6 (15) (the earth connection
cable (31) must point downwards).
After securing the parts, treat all of them with
the anti-corrosion measures set out in the
BMW standard.
EN/15
Advertisement
Table of Contents
