To Install And Route The Power Supply Cable - BMW 82 82 0 304 134 Installation Instructions Manual

8.

To install and route the power supply cable

0
A
A2-A6
30
A1
31
0
A
A
0
30
X322
A4
0
Retrofit / Installation kit No. 82 82 0 304 134 (others see cover sheet)
Installation Instructions No. 01 29 0 141 494
4/5
30
039 0242 B
30
039 0243 B
16
A2
A3
039 0244 B
Issue date: 05.2003
0
Direction of arrow = Driving direction.
Use textile adhesive tape (30) to attach the branch
A1 of the power supply cable A, to the roof hoop
(4/5), as shown in the figure (excess length about
200 mm).
Then route the power supply cable A with
branches A2 to A6 into the boot on the left.
Only for cars with an alarm system
Use textile adhesive tape (30) to attach the
connection cable (31) for the ultrasonic module.
Route the power supply cable A along the
0
standard wiring harness to the retrofit plug
connector X322 in the boot on the left and use
textile adhesive tape (30) or the cable ties already
in the vehicle to attach it.
Disconnect retrofit plug connector X322.
0
Unlock the white 12-pin socket casting (30) of the
retrofit plug connector X322.
Disconnect the socket casing slot PIN1, red/green
cable.
Connect the socket contact of the branch A2, red/
green cable, into the empty slot PIN1
of the 12-pin socket casing (30).
Connect the disconnected socket contact, red/
green cable, into the black socket casing (16).
Connect the black socket casing (16) to the plug
casing of the branch A2, red/green cable.
EN/17