Advertisement
7
Replace the back cover.
Make sure that the cables are tucked away inside the housing so that they do not obstruct the cover. Align the
back cover with the unit and settle the cover into place. Tighten the four screws.
8
Attach the antennas.
Being careful not to touch the antenna tips, screw the antennas onto the SMA connectors and hand tighten
them. After network startup, you may need to adjust the antennas to fine tune radio coverage.
9
Reinstall the access point.
Reconnect the Ethernet cable and reattach the access point to the wall mounting plate. Adjust the antennas to
improve the radio signal, if necessary.
Advertisement
