INDICATOR LIGHTS
4.
Power LED
5.
Status LED – indicates transmitter and receiver are connected to each other
6.
Link LED – indicates HDMI input is connected
7.
HDCP LED – indicates signal is encrypted (flashing means not encrypted)
INSTALLATION
1.
CONNECT CABLES You can use unshielded or shielded twisted pair. It is technically
possible to use either CAT5e or CAT6 cable. CAT6 is superior quality and has a lower skew
rate.
NOTE: The most common cause of problems is poor quality CAT5e/6 cable.
Vision strongly recommends you use quality CAT6 cable with a low skew rate.
2.
POWER ON HDBT DEVICES
3.
POWER ON DISPLAY
4.
POWER ON SOURCE
4
5
6
7
TC2-HDBTv2_manual_en_v1.doc
5