Engine - Jonsered FR 2312 MA Operator's Manual

To clean the product
CAUTION: Do not use a high pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt from on and around
the transmission, the transmission air intake, and the

engine.

• Use running water from a hose to clean the product.
Do not use a high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, remove it and hose it
down with water.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To clean the cold air intake of the
engine
WARNING: Stop the engine. The cold air
intake rotates and can cause injury to your
fingers.
• Make sure that the intake grille on the engine cover
is not blocked. Remove grass and dirt with a brush.
18
• Open the engine cover. Make sure that the cold air
intake is not blocked. Remove grass and dirt with a
brush.
To remove the covers
To remove the engine cover
1. Release the clips on the engine cover.
2. Fold the engine cover rearward.
To remove the belt cover
1. Release the clip on the belt cover.
2. Remove the belt cover.
512 - 001 - 26.01.2018