Panasonic AW-HS50E Operating Instructions Manual page 33

4. Specifications
SDI outputs
DVI-D output
Video delay time
HD: Serial digital component (SMPTE 292M)
SD: Serial digital component (SMPTE 259M)
2 signal lines: SDI OUT 1, SDI OUT 2
(Only the SDI OUT 1 signals are split into two)
HD: SMPTE 292M (BTA S-004B) standard complied with
• Output return loss More than 15 dB (5 MHz to 1.5 GHz)
0.8 V [p-p] 10 % (75 )
• Output level
• Rise time Less than 270 ps
• Fall time Less than 270 ps
• Difference between rise time and fall time
Less than 100 ps
• Alignment jitter Less than 0.2 UI (130 ps)
• Timing jitter Less than 1.0 UI
• Eye aperture ratio More than 90 %
0 0.5 V
• DC offset
SD: SMPTE 259M standard complied with
• Output return loss More than 15 dB (5 MHz to 270 MHz)
0.8 V [p-p] 10 % (75 )
• Output level
• Rise time Less than 1.5 ns
• Fall time Less than 1.5 ns
• Difference between rise time and fall time
Less than 0.5 ns
• Jitter Less than 0.2 UI
Digital RGB (Vertical frequency: 60 Hz):
XGA (1024  768), WXGA (1280  768), SXGA (1280  1024),
WSXGA+ (1680  1050), UXGA (1600  1200), WUXGA (1920  1200)
Digital RGB: 1080/50p, 1080/59.94p
  High-resolution multi view mode supported:
Signals are also output with a high resolution even when SD has been selected
as the system mode.
When the high-resolution multi view mode is enabled, MV is assigned to
the DVI OUT connector, and MV cannot be assigned to the SDI OUT 1
connectors or SDI OUT 2 connector.
  Analogue output signals are not supported.
1 frame (F)
  Video signals that have passed through the PinP, multi view display, DVI-D input
or DVI-D output will be delayed in each case by up to one frame.
32 (E)