Table of Contents
Advertisement
9 Recovery Mode
The user will now be presented with a pop up box asking them to confirm the action (Figure
85)
Figure 85 - Reboot Confirmation Pop Up
The unit will now reboot. The unit should now start up in normal mode but with the IP address
set to 169.254.1.1 and the Ethernet interface set to auto-negotiate and auto-MDI/MDIX.
Should the unit fail to start up the user should refer to Section 10 "Fault Finding".
9.3
Erase Configuration
To erase the unit's configuration the user should press the "Erase Configuration" button on
the "Recovery Options" page (Figure 79). The user will now be presented with a pop up box
asking them to confirm the action (Figure 86).
Figure 86 - Confirm Erase Configuration Pop Up
On confirmation the following page will be displayed (Figure 87). The user should now reboot
the unit by pressing the "Reboot" button.
Figure 87 - Erase Configuration Successful Page
147
Advertisement
Table of Contents
