Preparing The Remote Control Unit - Loewe bild 1.65 Quick Start Manual

Loewe bild 1
Quick start manual
Operating controls on the TV set

Preparing the remote control unit

Functions of the operating controls bild 1.65 / bild 1.55 / bild 1.40/32
2
1
3
1
Mains switch:
The mains switch is located on the bottom of the set.
Always return the TV set to Standby mode before switching it off
with the main switch.
2
Display:
white: TV set in standby.
white, intermittent: TV set starts.
green: TV set switched on.
red: timer recording active.
blue: TV set in standby and background operation
active (EPG data updating, software
update).
3
IR receiver:
Infrared receiver for receiving the remote control commands.
4
Key M (bild 1.55) / joystick direction M (bild 1.40/32):
TV set in standby mode: switch on TV set with the last selected
mode (TV/Radio).
TV set switched on: call direct control on TV set.
Direct control on TV set: up
5
Key R (bild 1.55) / joystick direction R (bild 1.40/32):
TV set in standby mode: switch on TV set with the last selected
mode (TV/Radio).
TV set switched on: toggle TV mode and radio mode.
Direct control on TV set: down
6
M
4
5 R
6 V+
V-
7
8 P+
6 4
P-
9 10
7
M
_
10 +
5
R
bild 1.55
bild 1.40/32
.
.
6
Key V+ (bild 1.55) / joystick direction + (bild 1.40/32):
TV set in standby mode: switch on TV set with the last selected
mode (TV/Radio).
TV set switched on: Increase volume.
Direct control on TV set: to the right
7
Key V– (bild 1.55) / joystick direction – (bild 1.40/32):
TV set in standby mode: switch on TV set with the last selected
mode (TV/Radio).
TV set switched on: Reduce volume.
Direct control on TV set: to the left
8
Key P + (bild 1.55):
TV set switched on: Programmme + (next station).
9
Key P – (bild 1.55):
TV set switched on: Programme – (previous station).
10
On/Off button (bild 1.55) / Press joystick (bild 1.40/32):
Switching on in standby mode
Switching off to the standby mode
Preparing the remote control unit
Removing the battery protection
The remote control is supplied with batteries. To make them ready for
use, remove the plastic flag out as shown below.
Inserting or replacing batteries
Press on the embossed arrow whilst pushing the battery cover down.
Only use leak-proof micro-cells of the LR 03 (AAA) Alkali-Manganese
type. Do not use different types of batteries and old and new batteries
together.
The batteries used must not be exposed to excessive heat such as
sunlight, fire or similar!
The position of the batteries is indicated in the battery compartment
(in opposite directions). Pay attention to the correct polarity of +
and – when inserting the batteries.
If the batteries are too weak after longer use, the TV set prompts you to
change the batteries. Dispose of used batteries in an environmentally
friendly way (see chapter Environment / Legal information).
Push the cover back on from below after having inserted the batteries.
Adjusting the remote control unit for operating the TV set
Press the TV key.
.
.