Initial Installation; Installing The Tv Set; Removing The Protective Foil; Preparing The Remote Control Unit - Loewe Operating Instructions Manual

Initial installation

Installing the TV set

Install as manually rotatable table unit with the Screen Table Stand
included.
See Accessories (page 58) for other installation possibilities.

Removing the protective foil

Slowly and carefully remove the protective foil on the trim.

Preparing the remote control unit

Inserting or replacing batteries
Press the embossed arrow and push down the battery
compartment cover.
Insert two alkaline manganese LR 0 (AAA) batteries;
ensure that the + and – poles are correctly positioned!
Slide the cover up from below.
Adjusting the remote control for operating the TV set
Press the TV button.
See page 5 to learn about operating other Loewe
devices.
- 10

Connecting the TV set

Connecting to the mains
Remove the cover for the connections.
Connect the TV set to a 0-40V outlet:
First plug the small plug of the mains cable into the
mains connection on the rear of the TV, then plug the
large plug into a mains power outlet.
Connecting the antenna
Analogue / DVB-C / DVB-T antenna:
Plug the antenna plug of antenna system, cable system,
or room antenna into the ANT2 socket.
The connecting cable between ANT-TV – ANT OUT is
plugged at the factory.
Satellite antenna, if retrofitted
Connect an antenna plug, e.g. from the antenna change-
over switch or from the twin-LNC of the satellite system
to the sockets ANT-SAT and ANT-SAT2.
When connecting only one SAT antenna cable, connect
it to ANT-SAT.
ANT
ANT
SAT
Connections on the back of the set (see also page 5).
Replace the cover over the connections.
Receiving coded stations
When using a CA module and a Smart-Card to receive
coded stations, please observe the handling of the CA
module (see page 4).
:
ANT
SAT
TV
R
0-40V~
50/60Hz