Table of Contents
Advertisement
Power Requirements
Switch power connection is via two switched connectors on the front panel, as shown in
Figure 2-1. The switch power requirements are:
Properly wired, earth-grounded outlet
Input voltage: 85 - 265 VAC
Total power: Up to 110 watts (depending on configuration, see Appendix A,
Specifications)
Input line frequency: Nominally 47 to 63 Hz
The switch has an autoranging power supply that automatically accepts voltages and line
frequencies within its ranges. A green power on indicator light is located above the
power switch in the power supply module.
NOTE:
includes one power supply unit and the 2402 includes two power supply
units.
Power Supply 2
Figure 2-1
NOTE:
however, there is no other provision for surge protection built into the
switch's power supplies. An installation should include normal
provisions to assure clean power.
Site Location
The switch should be installed in a secure or limited access site to control unauthorized
access to the switch's cabling and power connections.
SilkWorm 2400 Hardware Reference Manual
®
The SilkWorm
2400 is available in two models. The 2401
Model 2402 with Two Power Supplies
The switch meets IEC 801-5 surge voltage requirements,
Unpacking the Switch
Power Supply 1
2-3
Advertisement
Table of Contents
