Brocade Communications Systems SilkWorm 2400 Hardware Reference Manual page 19

Brackets are provided as part of the slide kit. The brackets are used to secure the switch
to the rack. As shown in Figure 2-2, the two holes located towards the front of the switch
are used with the brackets. All the other holes are used for slide mounting.
Figure 2-2
1 Mount both stationary slide portions to the front and rear rack rails.
2 Engage the slide mounted on the switch with the stationary slide portion mounted on
the rack, and press toward the rear until the latches engage.
3 Press the switch until the brackets are firmly seated on the rack front supports.
4 Secure the switch to the rack using the provided screws and nuts as shown in Figure
2-2.
5 Connect the switch to power. This completes the switch rack installation.
SilkWorm 2400 Hardware Reference Manual
Use brackets to attach switch to the rack here
Mounting the switch
Unpacking the Switch
2-5