Lubrication; Greasing The Bearings; Engine Maintenance; Engine Safety - Toro 74784 Operator's Manual

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all the
lubrication points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, and
disengage the blade-control switch.
2. Ensure that the parking brake is engaged,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
27) with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
Figure 26
1. Front caster tire
Figure 27
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance
2. Check the tire pressure
every 25 operating hours
4. Connect a grease gun to each fitting
and Figure 27).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
(Figure 26 and Figure
g027752
decal106-8717
3. Grease every 25 operating
hours
4. Engine
(Figure 26

Engine Maintenance

Engine Safety

Shut off the engine before checking the oil or adding
oil to the crankcase.

Servicing the Air Cleaner

Note:
Service the air cleaner more frequently (every
few hours) if operating conditions are extremely dusty
or sandy.
Removing the Elements
1. Park the machine on a level surface and
disengage the blade-control switch (PTO).
2. Engage the parking brake, shut off the engine,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Clean around the air-cleaner cover to prevent
dirt from getting into the engine and causing
damage.
4. Lift the cover and rotate the air-cleaner assembly
out of the engine
27
(Figure 28).
Figure 28
g027800
g027801