Grandstream Networks HT818 User Manual page 21

03 "Subnet " + IP address
04 "Gateway " + IP address
05 "DNS Server " + IP address
07 Preferred Vocoder
10 "MAC Address"
12 WAN Port Web Access
13 Firmware Server IP Address
14 Configuration Server IP
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
86 Voice Mail
99 "RESET"
"Invalid Entry"
"Device not registered"
Same as menu 02
Same as menu 02
Same as menu 02
Press "9" to move to the next selection in the list:
•
PCM U / PCM A
•
iLBC
•
G-726
•
G-723
•
G-729
•
OPUS
Announces the MAC address of the unit.
Note: The device has two MAC addresses. One for the
WAN port and one for the LAN port. The device MAC
address announced is the address of LAN port.
Press "9" to toggle between enable / disable.
Default is disabled.
Announces current Firmware Server IP address.
Enter 12 digit new IP address.
Announces current Config Server Path IP address.
Enter 12 digit new IP address.
Upgrade protocol for firmware and configuration update.
Press "9" to toggle between TFTP / HTTP / HTTPS
Announces Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the
following three options:
•
Always check
•
Check when pre/suffix changes
•
Never upgrade
Enter the target IP address to make a direct IP call, after
dial tone. (See "Make a Direct IP Call".)
Access to your voice mails messages.
Press "9" to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook If
the device is not register and the option "Outgoing Call
without Registration" is in NO
HT81x User Guide
P a g e | 20