Verizon Smart-Cell User Manual page 24

Downlink Downlink path gain is
Hardware 6dB less than RSSI
failure plus Output Power
Downlink Input RSSI from
Donor Donor site is 8dB less
power too than Downlink Low
low Input Limit
When the VSWR
Downlink Ratio on the Server
VSWR Port is greater than
3 : 1
Downlink
Downlink Input
Donor
Power exceeds -
power too
25dBm
high
Downlink Synthesizer (in
Synthesizer Downlink path) has
failure occur Failure
Downlink If an external signal is
Interfere higher than the in
power band signal, more
exceeded than 15dB signal
Uplink Out
Uplink Output Power
of band
exceeds Uplink Upper
emissions
Limit
out of spec
* By default, if the Downlink Low Output Variance is
set to 10dB, the Repeater will not report this alarm.
* Increase the Downlink Low Output Variance on the
RF Configuration Page.
* By default, if the RSSI Lower Limit is set to -93dBm,
the Repeater will not report this alarm.
* Decrease the Downlink Low RSSI Limit level on the
RF Configuration Page.
* Increase the RSSI level into the Repeater.
* "Sweep the line" to check for loose or damaged
connectors and/or cabling.
* If after checking the entire Server side, the VSWR
alarm still exists and the system is working fine,
Disable the alarm on the Alarm Configuration page.
* Check the direction of donor antenna
* Even if higher input power after the modifying
direction of donor antenna, Be adding an attenuator
at the Donor port.
* By using a switch on the back of the repeater,
resets the power
* Call to GST's Tech Support Team and exchange the
AMP unit.
* Call the GST's Tech Team, resolved in accordance
with the procedure.
* The Uplink Output Power should not exceed the
maximum composite power spec for this unit.
* If the Uplink Output Power is not exceeding the
composite power spec for this unit, try to increase
24
Verizon User Manual
Smart-Cell Repeater