Setting Up The Repeater; Quick Gui/Configuration; Quick Setup - Verizon Smart-Cell User Manual

4.2. Setting up the Repeater

4.2.1. Quick GUI/Configuration

Use the following steps to commission the Repeater after all the cabling and antennas
are fixed in place and the Repeater is supplied with proper electrical power.
repeater will need a good quality stable Downlink RSSI input level in the range of -
85dBm to -60dBm.
1) Connect your laptop to the repeater with a Crossover Ethernet cable.
2) Verify that your laptop has all wireless connections off and is Obtaining an IP address
automatically, or is using a proper fixed IP address such as: Use the following IP
address: 172.16.6.81 with a Subnet Mask of 255.255.255.252.
3) Open Internet Explorer and go to: 172.16.6.81
4) User name: admin
5) Password: admin

4.2.2. Quick Setup

1) Go to the RF Configuration page.
2) Before the Amplifier (HPA) can be turned on, set the Uplink and Downlink
attenuation (ATT) to the maximum value and click Apply.
3) Select the correct Band Block and set the ALC Downlink and Uplink Limits to the
desired
Downlink and Uplink Limits to the desired levels).
4) To check the Repeater's status, click on the Status page.
5) To change the Repeater's gain/attenuation, adjust the Uplink and Downlink
attenuation in equal amounts not more than 5dB at a time and click Apply.
level and click Apply. (To adjust the Output Power, change the ALC
21
Verizon User Manual
Smart-Cell Repeater
The