Audio/Visual Alert for Instant-On/Pulsed Radar
This type of signal appears suddenly when a Radar
unit is "triggered". The instant-on or pulsed alert
consists of an intense, three-second, X, K or Super
Wideband Ka audio "burst", coupled with the flashing
of the four-
(Bright/Dim/Dark) Button
DRK
The
button allows selection of a dim or dark setting
DRK
for all
LEDS
once. A single "beep" confirms your selection. To
completely cancel the illumination of all
a second time. You'll notice the city/highway
dim to confirm your unit is receiving power. To return to
a full bright setting, press the
two "beeps" confirm this selection. Use of the
button does not affect audio alerts.
Important – if you press the DRK button and do not receive
audible confirmation, the audio level has been set too low.
(Audio Mute/Volume Control) Button
AUD
Manual Muting of Audio Alerts (Radar and
Whether Auto-Mute is selected
Selectable Features, the audio alerts can be completely
muted by pressing the
No audible alert will be heard for approximately 12
seconds. If the signal is still present after 12 seconds,
the unit will remain in manual mute mode.
Volume Control
Press and hold
control. Release the
your desired audio setting. To reverse direction of the
volume, release and press
Note – because Laser alerts are not lengthy or
sustained, muting is not required (see page 17).
7
display.
LED
. To engage dim mode, press the
AUD
button to engage the volume
AUD
AUD
button a third time;
DRK
or
ON
OFF
button during an alert.
button when you have reached
a second time.
AUD
button
DRK
, press
LEDS
DRK
remains
LED
DIM
)
™
SWS
in
Need help?
Do you have a question about the VECTOR LR and is the answer not in the manual?