Damage Requiring Service - Futurecom 8A535X03 User Manual

IMPORTANT
If an outdoor antenna is connected, make sure the system is always grounded to allow
for protection against voltage surge and built-up static charges. Outdoor antennas
should always be located away from power lines.

DAMAGE REQUIRING SERVICE

This product should be serviced by qualified service personnel when:
Objects have fallen, or liquid has been spilled into the product; or
The product has been exposed to rain or moisture; or
The product does not appear to operate normally or exhibits a marked change of
performance; or
The product has been dropped, or the cabinet damaged.
RF EXPOSURE
ATTENTION!
To satisfy FCC/IC RF exposure requirements, a separation distance 25.4cm (10.0") or
more should be maintained between the antenna of this device and persons. To
ensure compliance, operations at closer than this distance is not allowed.
RADIO OPERATOR
Futurecom requires the OCR operator to ensure FCC Requirements for Radio
Frequency Exposure are met. The OCR output power has to be set such that the
maximum Effective Radiated Power (ERP) does not exceed 5W at the antenna. The
minimum distance between all possible personnel and the antenna at 5W ERP must
be at least 25.4cm (10.0").
FAILURE TO OBSERVE THE MPE DISTANCE EXCLUSION AREA AROUND THE ANTENNA MAY
EXPOSE PERSONS WITHIN THIS AREA TO RF ENERGY ABOVE THE FCC EXPOSURE LIMIT
FOR BYSTANDERS (GENERAL POPULATION). IT IS THE RESPONSIBILITY OF THE OCR
OPERATOR TO ENSURE THAT MPE LIMITS ARE OBSERVED AT ALL TIMES DURING
REPEATER TRANSMISSIONS. THE OCR OPERATOR MUST ENSURE AT ALL TIMES THAT NO
PERSON COMES WITHIN MPE DISTANCE FROM THE ANTENNA.
ATTENTION!
To satisfy FCC/IC RF exposure requirements, the OCR site operator must comply
with FCC/IC requirements for maximum site EIRP radiated power and antenna height
limits.
8A535X03 Rev. Preliminary-00 Page 6 of 17