Janome Stirling 8002D Instruction Manual page 17

w
e
(A)
(B)
AFTER SALES SUPPORT
AUS 1300 526 663
AUS Hotline Costs
Adjustment of Needle Plate Setting Knob
(Changing to Standard Overlock or Rolled
q
Hemming)
1.
2.
3.
4.
5.
6.
t
r
(A) Standard Overlock
* The chaining finger is located beside the needle
q
t
(B) Rolled Hemming
* Pull the needle plate setting knob from "S" to "R"
q
t
Turn off the power switch and unplug the
machine.
Open the looper cover and side cover.
Deactivate the upper knife.
Push the cutting width adjusting dial to the right
as far as it will go, then, move the needle plate
setting knob to the guide line of S (for Standard
Overlock) or R (for Rolled Hemming). Release
the cutting width adjusting dial to the left gently.
Set the upper knife to up position.
Close the looper cover and side cover.
q Chaining finger
w Guide line
e Cutting width adjusting dial
r Upper knife
t Needle plate setting knob
plate as shown in diagram (A) for guiding the flat
edge of the fabric for overlock sewing.
position, so that the fabric edge will be rolled for
hemming, picot edging and narrow hemming.
enquiries@esqaustralasia.com.au
MODEL: 8002D PRODUCT CODE: 52832 04/2016
17