When Changing The Keeping Warm Temperature; 更改保溫溫度時 - Panasonic SR-JHS10 Operating Instructions Manual

Problems / 症 狀
The sparks came
out from the plug.
插頭冒出火花
When the display
is off.
當顯示面板關閉時
Important Information
敬請注意
�如果直接將米或水放入電飯煲的本體，而非放入內鍋中

When changing the keeping warm temperature

(Set at 74 in the beginning.)
更改保溫溫度時
�Change to [76] when the rice has odour and change to [72] when changing the color or drying.
�散發出香味時請設定為「76」使其變色、欲乾燥時請變更為「72」 。
1
Press
按 ，將 "
2
Press
(You hear a beep on third time.)
按三次 。
(第三次會發出「嗶」聲。)
3
Each time pressing
is changed to 74 · 76 · 72.
(Press the key while displaying for 4 seconds.)
Setting is complete when the display shows current time.
按 。
按壓時會依序變換成74、76、72。
(請於顯示的 4 秒內按下。)
若顯示「現在時間」，表示已完成變更。
SR-JHS10(HK).indd 23
¡When plug or unplug, sometimes the small sparks come out.
This is typical for an IH (induction heating system). It is not breakdown.
¡將插頭插入或拔下時，有時會冒出些微的火花。
對於創新磁應導熱而言，這是正常的。 這並不代表裝置已故障。
¡Is display showing [8:30] when plugged in?
[Show] Lithium battery is wearing out.
If the plug is in, cooking and keep warm function can be used.
When using timer, it is required to set time every time using it.
The Battery cannot be changed by a customer because it is fixed in the main body.
[Unshown] Display is breakdown.
If you would like to replace it, please make enquiries at the store that you
purchased the product from or the repair service.
¡插入插頭時，面板上是否顯示「8:30」？
[顯示] 鋰電池即將耗盡。
如果已插入插頭，則可使用炊煮和保溫功能。
每次使用定時器時，均要設定時間。
由於電池是固定在本體中，因此，顧客無法自行更換。
[不顯示] 顯示面板故障。
如果要更換電飯煲，請與出售本產品的經銷店或維修服務視窗商談。
�If you put rice or water in the main body of the Warm Jar without putting the Inner Pan
Please make enquiries at the authorized dealer.
（開始使用時設定為74）
to point [ ] to [cake].
" 調到 "Cake" 位置。
three times.
, display
Points to check / 請檢查
請與經銷店商談。
Current setting temperature is
shown. (Display for 4 seconds.)
顯示現在設定中的溫度。
( 顯示 4 秒鐘 )
Reference Page
參照頁碼
—
—
—
—
遇
到
困
難
時
(Current time)
( 現在時間 )
23
08.11.28 11:46:27 AM