Panasonic SR-JHS10 Operating Instructions Manual page 21

Wash after
every use
每次使用後均需清洗
Inner Lid 蓋加熱板
■Removing the Inner Lid
■拆卸方法
■Attaching the Inner Lid
■安裝方法
●Please wash the Inner Lid immediately after cooking if seasoning was used (after cooking mixed rice
●Remove all the excess water from the Inner Lid and Seal before attaching.
●若有使用調味料進行炊煮 (如什錦飯或粥等)，請於炊煮完畢後，立即清洗內蓋。
●將蓋加熱板和密封墊充分擦乾後再裝到本體上。
If it is not possible to clean the stainless steel part of the Inner Lid with detergents mentioned above,
use a non abrasive cleanser that does not scratch stainless steel, and wipe it off with a cloth or a
sponge.
置
若上述的清潔劑無法去除內蓋不鏽鋼部分的污垢，請使用不會刮傷不鏽鋼的非磨蝕性清潔劑，以抹布
或海棉來進行擦拭。
Pan Sensor 內鍋感應器
To clean the Pan Sensor, use diluted dish soap
(neutral) and scrub with nylon pads (brush) lightly.
Note
• If the Pan Sensor is not clean, the quality of
cooking may not be satisfactory. It may cause
over cooked rice or display error.
若要清潔內鍋感應器，請使用稀釋後的洗碗精
(中性)，並以尼龍墊 (刷) 輕輕擦洗。
須 知
●如果沒有將內鍋感應器擦洗乾淨，可能會導致
炊煮的品質不佳。 也可能會造成米飯煮得太爛
或顯示錯誤訊息。
SR-JHS10(HK).indd 21
Rice Scoop
飯勺
Pull the Inner Lid knobs located on the bottom
part of the Inner Lid towards you.
將位於內蓋底部的凸耳朝你的方向拉。
1
Insert the fixture located on the top part of the Inner Lid into the holes
at the top of the Outer Lid.
將位於內蓋上方的突起部插入外蓋上方的洞中。
2
Push the Inner Lid knobs (located on both sides) in until you
hear a clicking sound.
將凸耳 (位於內蓋的左右兩邊) 往內推，直到你聽到喀嚓聲。
Important Information / 敬請注意
or congee, etc). Otherwise foul odour, corruption, or rust may develop.
否則，可能會產生氣味，甚至可能會發生分解腐爛和生霉情況。
Cleaning the stainless steel part (metal part of the Inner Lid)
不鏽鋼部分（蓋加熱板的金屬部分）的保養方法
Ladle Inner Pan Inner Lid
粥勺 內鍋 蓋加熱板
Top part of the Inner Lid
「 」 （上）標記
Upper Frame 上 緣
Wipe with a well-wrung cloth.
Important Information
• Do not pour water inside to clean.
請用擰乾的抹布擦拭
乾淨。
敬請注意
●請勿將水倒在裡面。
Taste Catcher Steaming Basket
美味感應裝置 蒸籠
Seal
密封墊
Inner Lid knobs
凸耳
Fixture
突起部
使
用
方
法
21
08.11.28 11:46:25 AM