Powering Up And Down; Figure: 14 - Led Indicator And Power Switch - Enfora Spider AT 3000 User Manual

6 Powering Up and Down

The button on the underside of the Spider AT 3000 functions as both the power switch and the activation
switch.
After the provisioning process is complete, the Spider AT 3000 will be activated. If you do not plan to
deploy the unit immediately, you should deactivate the Asset Tag, so as not to drain the battery.
To deactivate the Spider AT 3000, press and hold the power switch, located on the underside of the unit,
for three to five seconds. The LED will become solid red then go off. When the light is off, the unit is
deactivated.
Figure: 14 - LED Indicator and Power Switch
When you are ready to activate the Spider AT 3000, press and hold the power switch for three to five
seconds until you see a blinking light. The LED will then go off. When the light is off, the unit is activated.
- 32 -