Enfora Spider AT 3000 User Manual page 28

5. Remove the battery pack from the half of the Spider AT 3000 that contains the circuit board. You
don't need to disconnect the battery connector – just move the battery pack out of the way, so you
can access the USB connector.
6. Remove the battery pack from the half of the Spider AT 3000 that contains the circuit board. You
don't need to disconnect the battery connector – just move the battery pack out of the way, so you
can access the USB connector.
7. Install the SIM (See "SIM Card Installation" on page 56).
8. Turn the device on (See "Powering Up and Down" on page 32).
9. Connect the USB cable to the circuit board and to your computer.
10. Install the drivers (See "USB Driver Installation" on page 39).
11. Configure the Spider AT 3000 (See "Configure the Device" on page 17).
12. Once configuration is complete, remove the USB connector, and replace the battery pack.
13. Close the Spider AT 3000, and replace the screws.
14. The Spider AT 3000 is now activated, and will begin transmitting data.
Verify the Server is receiving messages from the device.
If you are ready to deploy the Spider AT 3000, mount the unit on the asset you need
to locate (See "Mounting the Unit" on page 20). If you are not ready to deploy,
deactivate the unit until you are ready (See "Powering Up and Down" on page 32).
- 16 -