Mounting The Device; Figure: 8 - Spider At 3000 And Mounting Hardware - Enfora Spider AT 3000 User Manual

4.1 Mounting the Device

Place a Lock-Washer on one of the Screws. Now place a Flat-Washer on the Screw, See "Mounting the
Device". Repeat this process with the remaining three Screws.
Figure: 8 - Spider AT 3000 and Mounting Hardware
Insure the Device is activated (See "Powering Up and Down" on page 32). Align the Device with the pre-
drilled screw holes. Insert one of the screws (assembled above) through one of the screw holes in the
Device. Partially tighten the Screw into the mounting surface. Repeat this process until all four screws are
started into the mounting surface. Now tighten the four screws until they are snug. Tighten the Screws to
2.5 in-lb torque.
- 24 -