Initial Setup; Figure: 5 - Internal View Of Spider At 3010 With Circuit Board And Battery Pack - Enfora Spider AT 3000 User Manual

3 Initial Setup

Please follow these steps to start using the Spider AT 3000 series:
1. Make sure you have the following items:
Spider AT 3000 series device.
l
USB Drivers.
l
USB cable (USB-A to 5-Pin Mini USB)
l
2. Remove the Spider AT 3000 from the packaging material.
3. The Spider AT 3000 will be assembled loosely with four screws. Fully loosen the screws and separate
the two halves of the unit.
4. Make sure the battery is connected (See "Connect the Battery" on page 31).
Figure: 5 - Internal View of Spider AT 3010 with Circuit Board and Battery Pack
To Reduce the risk of ignition of a flammable or explosive atmosphere; batteries
must be inserted or changed only in a location known to be non-hazardous.
- 15 -