Page 1
416 Li Instruction manual Pressure sprayer Translation of the original with rechargeable instructions battery Important! Read this instruction manual carefully before first operation and strictly observe the safety regulations! 9 416 108 ENGLISH 01/2015...
Page 2
Your authorised SOLO dealer will be glad to assist Wear the prescribed protective clothing. you with any questions. EC declaration of conformity Wear protective gloves.
Table of contents 1 Wearing parts ............................4 2 Warranty ..............................4 3 Safety regulations ............................. 4 3.1 Correct use / areas of application 4 3.2 General safety instructions 5 3.3 Work clothing / personal protection equipment (PPE) 5 3.4 Safe handling of spraying agents 6 ...
1 Wearing parts / 2 Warranty / 3 Safety regulations 1 Wearing parts 3 Safety regulations Various parts are subject to application-specific 3.1 Correct use / areas of application wear or to normal wear and must be replaced in good time if necessary. ...
SOLO dealer. He also has access to the nece- The operating instructions must be kept available ssary spare parts lists, from which the required at all times wherever the device is used or stored.
The charger is only designed to recharge the rechargeable battery that is supplied by SOLO Stop working immediately if you start to feel for this pressure sprayer. Ensure that the battery unwell while working, or if you become unusually is always correctly connected to the charger tired.
flames instantly remove the unit from your body All repairs must only be performed using SOLO and take a safe distance. In case of fire, you genuine replacement parts.
4 Type plate / 5 Operating and functional components 4 Type plate a: Name and address of the manufacturer b: Product designation c: Type designation "Typ" d: Serial number "SN" e: Weight (ready for operation, tank empty) "m " net. f: Max.
Page 9
5 Operating and functional components View: top, spraying agent tank opened View: right hand side, lower part View: protective casing opened Charger and mains outlet adapter ENGLISH 9...
6 Preparing the device for use 6 Preparing the device for use Assembly of the spray tube (10): 6.1 Assembly The pressure sprayer with rechargeable battery is dismantled before it is dispatched. It must be fully reassembled again before it is used. Connecting the rechargeable battery: ...
6 Preparing the device for use 6.3 Charging the battery Lift up the two sliding clips again to release the straps. Always switch off the pump when the charger is connected. The rechargeable battery needs to be charged before you can use the pressure sprayer for the first time.
Cleaning the filling strainer: See section 9.8 until no more fluid is sprayed. If the strainer is damaged, replace it by a genuine SOLO replacement part (part no.: 42 00 104, mesh Spraying agent volume: aperture: 0.7 mm [0.0276"]). Mix the spraying agents according to the...
In setting I, the switch-off pressure may not Recommendation: Use the special SOLO cleaner always be attained even if the shut-off valve is for plant protection sprayers (dosing bottle of closed, and the pump will then run continuously 500 ml [approx.
In this event have the device checked by an autorised SOLO 8.2 Residual spraying agents / workshop. finishing spraying 9.3 Checking the spray nozzles and the...
Rinse the nozzle attachment with clean water. The replacement glass fuse 5x20 mm 4A (part no.: Disassemble the nozzle attachment (11). 00 84 055) can be ordered at your local SOLO dealer. Replacing the fuse: Release the fuse holder (14) with a screwdriver (turn it half a turn anti-clockwise) and then pull it out.
Ensure that the unit cannot be used by supplied with the spraying agent. unauthorised persons, in particular children. Recommendation: Use the special SOLO cleaner for plant protection sprayers (dosing bottle of 500 ml [approx. 16.9 oz], part no.: 49 00 600).
(including the support frame), if any of the adjustment settings are incorrect or if the equipment is not working properly in any way. In this event have the device checked by an autorised SOLO workshop. If you have any questions please refer to your authorised SOLO dealer.
12 Specification and special accessories 12 Specification and special accessories Spraying agent tank Max. fill volume 20 l [5.28 gal] Tank volume 22 l [5.81 gal] Filling strainer Mesh aperture 0.7 mm [0.0276"] Part no. 42 00 104 Residual volume not properly discharged by the device <...
Need help?
Do you have a question about the 416 Li and is the answer not in the manual?
Questions and answers