Table of Contents
Advertisement
72
CCM840/1640 Installer/User Guide
Show Port Command Parameter
Parameter
Description
<port>
Port number.
Default = your port
ALL
Displays information about all ports.
NAMES
Displays only port numbers and names. If a port has not been given
a name with a Port Set command, the default name is displayed. A
default name contains the last three octets of the MAC address plus
the port number.
The following tables list the display fields for a SHOW PORT command that
specifies one or all ports.
Show Port Command Display Fields for Console Ports
Field
Content
Port
Port number.
Serial Port Settings
Comma-separated string of port values: baud rate, number of bits,
parity, stop bits, fl ow control, socket number, time-out value and CLI
access character. The CLI character is preceded by POR CLI= if
it was defi ned with a Port Set command or by SER CLI= if it was
defi ned with a Server CLI command.
TX Bytes
Number of bytes transmitted.
RX Bytes
Number of bytes received.
Errors
Number of TX/RX parity and framing errors.
Power
Device power status, if monitoring is enabled. ON indicates the
device is on, OFF indicates the device is off. If monitoring is
disabled, this fi eld is blank.
Toggle **
Toggle value (from Port Set command).
Power Signal **
Signal and state being monitored for device power status (from Port
Set command).
Logical name **
Logical port name, which contains last three octets of MAC address
plus the port number.
User *
Username (from User Add command).
Level *
User's access level (from User Add and User Set commands).
Access *
User's access rights (from User Add and User Set commands).
Duration *
Duration of user's session.
* Displayed only when the command specifi es a single port that is currently being accessed.
** Displayed only when the command specifi es a single port that is not in use.
Advertisement
Table of Contents
