Server Ppp Command - Equinox Systems Equinox Console Manager CCM1640 CCM1640 CCM1640 Installer/User Manual

You will need a TFTP server. Download the latest FLASH image. Save the
image file to the appropriate directory on the TFTP server.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER FLASH BOOT|APP HOSTIP=<tftp_add> IMAGE=<host_file>
Server FLASH Command Parameters
Parameter Description
BOOT Indicates the BIOS/Bootstrap image should be updated.
APP Indicates the application image should be updated.
HOSTIP=<tftp_add> IP address of TFTP server host.
IMAGE=<host_fi le> Name of fi le on TFTP server host containing the image fi le.
Example
The following command updates the CCM boot image program using the
image file name c:\winnt\system32\drivers\ccm4Øbt.img, which is located on
the TFTP server host located at 192.168.1.16.
> ser fla boot hostip=192.168.1.16 ima=c:\winnt\system32\drivers\
ccm40bt.img

Server PPP command

The Server PPP command enables or disables the PPP server on the serial CLI
port. For more information, see Connecting to devices using PPP in Chapter 3.
Once the PPP server has been configured with this command by specifying the
required addresses and masks, those values remain in the database. Later, if
you disable the PPP server and wish to reenable it with the same addresses,
you don't need to specify the address values again.
When you enable the PPP server, the serial CLI port must already be defined.
When you enter this command, you are prompted to confirm or cancel the
specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER PPP DISABLE|ENABLE
[LOCALIP=<local_ip>] [REMOTEIP=<rem_ip>] [MASK=<subnet>]
Chapter 5: CCM Commands
63