Intake System - GGP SV200 Workshop Manual

<= ...BACK... <=

6.3 INTAKE SYSTEM

GENERAL INFORMATION
The intake system uses an air filter which is directly
connected to the carburettor by means of a mani-
fold which conveys the air/petrol mixture towards
the induction valve.
The intake system can malfunction in the following
ways:
• difficult or failed start or insufficient power (if not
due to other causes):
= Air filter clogged
An inefficient filter can let dust or debris enter the
cylinder, causing premature wear to the piston rings
and cylinder.
The air filter is found on the left hand side of the
engine and can be inspected without having to
remove other parts.
SERVICING PROCEDURES
A) Maintenance of filtering element
1 Clean around the filter cover (1).
2 Remove the cover (1) by releasing the flap (2)
and remove the sponge filtering element (3).
IMPORTANT! The filtering element must be
kept clean and soaked in oil. Replace it if bro-
ken, cracked or fragmented. Do not use com-
pressed air for cleaning the filtering element.
3 Wash the foam element in liquid detergent and
water. Squeeze dry in a clean cloth.
4 Saturate the foam element (3) with 2 table-
spoons of clean engine oil and squeeze it a few
times to distribute the oil evenly (4).
5 Remove excess oil with a clean cloth.
6 With a jet of compressed air, clean inside the
seat (5) of the filter by removing dust and
remains of grass, making sure that the intake
pipe hole (6) is closed so that nothing gets
inside the pipe.
7 Install the foam element (3) in its housing and
refit the cover (1).
© by GLOBAL GARDEN PRODUCTS
SERVICE MANUAL
6.3.
1
INTAKE SYSTEM
[u 6.3.A];
1
2
4
6
5
SV200 R200
2007
••••
from to
1 / 1
page
3
3
4/2007