Insignia INS8727 Installation Manual page 13

www.insigniarange.com Last Modified: 08/02/2018
Step 3
Now attach your inner uprights to your front fixed glass panels by inserting these over
the thin rubber seals as shown by the arrows in the image.
Next screw the inner uprights to your curved rails using the ST25 screws.
(please note that the front uprights will need a pilot hole drilled before screwing)
Step 4
Now meet the front of the shower with the back panels.
Once you are happy with the alignment, run a bead of silicone up
the edge and along the inside of the front fixed glass. Then continue
apply RubberGum along the bottom of the panels and frame and
screw together using the ST20 screws and SW9 washers
13