Power Management; Fitting The Battery - Psion Teklogix netpad Win CE 4.1 User Manual

Chapter 2: Getting Started

Power Management

2.2.3 Power Management

The netpad is powered by a Lithium Ion rechargeable battery pack, which under
optimal operating conditions will provide power for a full shift. The netpad will
warn you when the main battery charge is low.
Note: How long your batteries last will depend upon how you use your netpad.
The netpad will use considerably more battery power when you are
recording sounds, have the brightness turned up, are using files stored on
a multimedia card, or are using Infrared.
You can take steps to help prolong your battery's life:
•
•
•
The netpad can be powered from AC when used in the docking station (see page 31).
When the netpad is powered from the docking station, it will also charge the
battery pack.
2.2.3.1
Before you can use the netpad you must fit the battery—slide it into place until it
clicks, as shown in Figure 2.7.
Important:
14
Psion Teklogix netpad Win CE 4.1 User Manual
Turn the screen brightness down.
Set automatic switch-off in the Power control panel.
Use files on the internal disk instead of an MMC, as the netpad requires
more power to write to the multimedia card.

Fitting The Battery

Always switch off the netpad before removing the main battery.
Figure 2.7 Battery Insertion
Battery Contact Pins
Battery Pack
Battery
Latch
Direction of
Insertion