Table of Contents
Advertisement
RingCentral
Datasheet | AudioCodes Gateway Configuration Guide
®
•
Navigate to VoIP / GW and IP to IP / Routing / IP to Hunt Group Routing and set up row 1 as shown. You can restrict outbound to FXO
to only allow 911 by replacing "*" in the Dest. Phone Prefix table to 911 or any variation of patterns you want to allow versus "*" for all
destinations, depending on your needs.
•
Navigate to VoIP / GW and IP to IP / Analog Gateway / Automatic Dialing and set port 3 as show below. "CO_Line" is just a marker to
allow for automatic dialing to occur when the FXO port receives an incoming call.
Advertisement
Table of Contents
Need help?
Do you have a question about the MediaPack 114 and is the answer not in the manual?