Table of Contents
Advertisement
ANCHORING
(NOTE:ANCHORS ARE NOT INCLUDED-MUST BE PURCHASED SEPARATELY)
There are different ways of anchoring the equipment, depending on the type of ground on which
the equipment is to be installed. Make sure that all anchors are below ground level to prevent
tripping.
You should consult your local contractor to decide the most appropriate way to anchor the
equipment in your location.
The following anchoring options may be considered:
Corkscrew Anchoring (Corkscrew Anchors not included)
If your soil is hard (clay, etc.), the corkscrew method may be suitable.
Be sure that the swing set is located on level ground.
Twist the corkscrew anchor into the ground until only the end with the hook is above the ground
and next to the leg. Insert the hook into the bottom opening of the leg.
Ensure that the hook is secured onto the leg opening.
Concrete Anchoring (Materials not included)
●
If the swing set is set up on grounds with sandy soil (soft) condition, it must be
anchored with concrete footing (concrete not included)
● Be sure that the swing set is assembled and placed on level ground
● Dig holes around swing leg tube, as shown in drawing in the next page. As you dig
deeper, enlarge the diameter of the hole to fix the cement
● Place 2 inches of brick or gravel underneath the leg, as shown in drawing in the next
page
● Use about 45 lbs. of concrete per leg
● Cover the concrete with dirt and protective surface material
● Allow 6-7 days for the concrete to dry properly
CONTACT XDP FOR PARTS AND SUPPORT AT 1.866.884.0535 or service@xdp-recreation.com
DO NOT RETURN TO RETAILER YOU PURCHASED AT.
5
Advertisement
Table of Contents
