Advertisement
Left side shown; repeat on the right side
1. Washer
2. Bolt (1/2 x 3 inches)
5. Install the removed bolts (1/2 x 3 inches), washers, and
nuts into the lowest hole in the ROPS plate (Figure 6).
Left side shown; repeat on the right side
1. Washer
2. Bolt (1/2 x 3 inches)
6. Torque all of the fasteners to approximately 45 N-m
(400 in-lbs).
5
Checking the Mower
Adjustment
No Parts Required
Procedure
Adjust the side-to-side level and the front-to-rear blade slope.
Use the relevant procedures in the Operator's Manual to verify
Figure 5
3. Fourth hole
4. Nut
Figure 6
3. Lowest hole
4. Nut
that the deck is level, and make any adjustments as necessary.
Refer to the Operator's Manual for more information.
6
Completing the Setup
Parts needed for this procedure:
1
Ignition key
1
Hose coupling (not included with CE models)
1
Operator's Manual
1
Engine Operator's Manual
1
Operator training material
Procedure
Checking the Tire Pressure
Check the front and rear tires for proper inflation; refer to
Checking the Tire Pressure in the Operator's Manual for the
recommended inflation pressure.
Checking the Side-Discharge Chute
Remove the packing restraint holding the side discharge chute
up and lower the chute into place.
Checking the Engine-Oil Level
Before you start the engine and use the machine, check the
oil level in the engine crankcase; refer to Checking the Oil
Level in the Operator's Manual.
Keep all the following items with the machine:
•
Ignition key
•
Hose coupling (not included in CE models)
•
Operator's Manual
•
Engine Operator's Manual
•
View the Operator training material before operating the
machine.
4
Advertisement
