Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Connecting the Battery
No Parts Required
Procedure
1. Locate the battery and negative battery cable in the
center of the machine.
2. Remove the black plastic cap from the negative
battery post. Remove the fasteners from the negative
battery cable and use them to secure the negative
battery cable to the negative battery post (Figure 4).
4
3
2
1
1. Bolt
2. Washer
3. Negative battery cable
Description
No parts required
No parts required
Ignition Key
Hose coupling
Operator's Manual
Engine Operator's Manual
Operator Training Material
5
G010257
Figure 4
4. Negative battery post
5. Nut
Qty.
–
Connect the battery.
–
Check the mower adjustment.
1
1
1
Complete the Setup.
1
1
2
Checking the Mower
Adjustment
No Parts Required
Procedure
Adjust the side-to-side level and the front-to-rear blade
slope. Use the relevant procedures in the Operator's
Manual to verify the deck is level and make any
adjustments as necessary. Refer to the Operator's Manual
for more information.
3
Completing the Setup
Parts needed for this procedure:
1
Ignition Key
1
Hose coupling
1
Operator's Manual
1
Engine Operator's Manual
1
Operator Training Material
Procedure
Setting Up the Motion Control Levers
13
Use