Setting Up The Motion-Control Levers; Completing The Setup; Checking The Mower Adjustment; Checking The Tire Pressure - Toro TimeCutter series Operator's Manual

5
Setting Up the
Motion-Control Levers
No Parts Required
Procedure
1. Locate the motion-control levers attached, but
folded down on the machine.
2. Remove the upper bolt (3/8 x 1 inch) and
washer; loosen the lower bolt (3/8 x 1 inch).
3. Raise the motion control levers to the upright
position.
4. Align the holes in the motion-control lever with
the holes in the control-arm shaft, and install the
bolt and washer removed previously. Repeat
this for both control levers.
Note:
Hand tighten all fasteners.
5. Move the motion-control levers to the park
position, raise the seat, and move the control
levers back to the center position (neutral).
6. Verify that the motion-control levers are properly
aligned.
Note:
Adjust as necessary. Tighten all
fasteners.
6
Checking the Mower
Adjustment
No Parts Required
Procedure
Adjust the side-to-side level and the front-to-rear blade
slope. Use the relevant procedures in the Operator's
Manual to verify that the deck is level, and make any
adjustments as necessary. Refer to the Operator's
Manual for more information.
7

Completing the Setup

Parts needed for this procedure:
1 Ignition key
1 Hose coupling (not included with CE models)
1 Operator's Manual
1 Engine owner's manual (non-Toro engines)
1 Operator training material

Checking the Tire Pressure

Check the front and rear tires for proper inflation;
refer to Checking the Tire Pressure in the Operator's
Manual for the recommended inflation pressure.
Checking the Side-Discharge
Chute
Remove the packing restraint holding the side
discharge chute up and lower the chute into place.
Checking the Engine-Oil Level
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking the Oil Level in the Operator's Manual.
Organizing the Material
Keep all the following items with the machine:
•
Ignition key
•
Hose coupling (not included in CE models)
•
Operator's Manual
•
Engine owners's manual (non-Toro engines)
•
View the operator training material before
operating the machine.
6