Setting Up An Ip Account - Gigaset E630A GO Manual

Data protection notice
When the device is connected to the router, it will automatically contact the Gigaset Support Server. It will
send the following device-specific information daily:
•
Serial number/item number
•
MAC address
•
Private IP address for the Gigaset in the LAN/its port numbers
•
Device name
•
Software version
On the support server, this information is linked to the existing device-specific information:
•
Gigaset.net phone number
•
System-related/device-specific passwords
Further information about the data stored in relation to the Gigaset.net Service can be found at:
www.gigaset.net/privacy-policy

Setting up an IP account

So that you are able to make calls via the Internet (VoIP), you must have at least one IP account
with an Internet telephony provider. You can register using the access data that you receive from
your provider (user name, authentication name, password etc.).
To register the phone with your provider, please use:
•
The VoIP wizard on the handset
•
Or the web configurator on a PC or tablet (
You can configure up to six IP accounts.
Registering using the VoIP wizard on the handset
As soon as the handset battery has sufficient charge, the
Message key on the handset will flash.
¤
Press the Message key
displayed text
If the wizard does not start properly or you have terminated it:
using the handset menu
¤
. . . Use
Wizard
If "New firmware available" is shown on the display, there is a firmware update
available for your phone.
To update firmware:
The Message key
¤
To start configuration: Press the Message key
Yes . . . the wizard starts
OK
to select
Yes . . . the new firmware is loaded (takes approx. 6 mins.)
will then flash again.
p. 97)
. . . scroll
Settings OK
.
Setting up an IP account
through the
Start the VoIP wizard
Telephony OK VoIP
13