Table of Contents
Advertisement
To erase all Voice Memos:
1. From the Standby mode, press MENU/OK to display the main menu.
2. Highlight V o i c e S e r v i c e , and press MENU/OK.
3. Highlight V o i c e M e m o , and press MENU/OK.
4. Highlight E r a s e A l l , and press MENU/OK.
5. Highlight Y e s , and press MENU/OK.
or
1. Follow the step 1 to 3 above.
2. Highlight P l a y , and press MENU/OK.
3. Display the memo list, highlight A l l , and press Options (right softkey).
4. Highlight E r a s e A l l , and press MENU/OK.
5. Highlight Y e s , and press MENU/OK.
S e t t i n g U p S c r e e n C a l l
This feature enables you to answer incoming calls by using pre-recorded
announcements, either one that is pre-recorded or one that you record. You can also
record the caller's message into the Voice Memo list (See "Using Voice Memo" on pages
77-79). You can decide whether you answer the call immediately or not during the
caller's recording.
A c t i v a t i n g S c r e e n C a l l
To start Screen Call when you have incoming calls:
1. Press MENU/OK to display the options.
2. Highlight S c r e e n C a l l , and press MENU/OK.
To set Auto Screen Call:
1. From the Standby mode, press MENU/OK to display the main menu.
2. Highlight V o i c e S e r v i c e , and press MENU/OK.
3. Highlight S c r e e n C a l l , and press MENU/OK.
4. Highlight A u t o , and press MENU/OK.
5. Highlight O n , and press MENU/OK.
If you want to change the answer time, enter your desired number (from 1 to 16
l
seconds) by using numeric keys or up/down of the Navigation key.
6. Press MENU/OK or OK (left softkey). Then the icon is displayed on the Standby
display.
Tip: If new caller's message is waiting, appears on the display.The memos recorded while activating
"Screen Call" are shown with "
" or "!" icon in the list. ("
79
": once played, !: not played yet)
Advertisement
Table of Contents
