Turning Your Phone On And Off; Unlocking The Phone; A D J U S T I N G T H E P H O N E 'S V O L U M E S E T T I N G - Sanyo SCP-5300 Operating Manual

S o f t K e y s
You can select the menus, which are described at the bottom line of the display by
pressing the corresponding soft keys (left/right). In this User Manual, the explanation
for selecting such menus are as shown below:
Press Memo.
(Press the soft key corresponding to Memo.)
T u r n i n g y o u r P h o n e O N a n d O F F
T u r n i n g y o u r P h o n e O N :
To turn your phone on, press and hold END/.
Once your phone is ON, it displays "Looking for service..." indicating that your phone is
searching for a signal. When your phone finds a signal, it automatically enters Standby
mode – the phone's idle state. At this point, you are ready to begin making and receiving
calls. If your phone is unable to find a signal after 15 minutes of searching, a Power
Save feature is automatically activated. When a signal is found, your phone
automatically returns to Standby mode.
In power save mode, your phone searches for a signal periodically without your
intervention. You can also initiate a search for PCS Service by pressing any key (when
your phone is turned ON).
Tip: The Power Save feature helps to conserve your battery power when you are in an area where there
is no signal.
T u r n i n g t h e P h o n e O f f :
Press END/ for one second until you see "Powering off" on the display.
Your screen remains blank while your phone is off.
U n l o c k i n g t h e P h o n e
1. Press and hold END/ to turn the phone on.
2. When "Locked" or "Full Locked" is shown on the display, press Unlock(left softkey).
3. Enter your four-digit lock code. For security purposes, the code is not visible as you
type.
9