Table of Contents
Advertisement
9.9 Fitting Type II Pulley
The Type II Pulley is fitted between the zipSTOP Brake Unit and the Type I Pulley as required to provide support
and redirection for the Redirection Line and connections to the Braking Line. The Type II Pulley is only re-
quired on the 2:1 Redirection Ratio set-ups.
Fit the Type II Pulley so as to ensure the position of the pulley will not allow contact or interference between
the rider and any lines or equipment
It is recommended that an overhead support line and link be used with the Type II Pulley to reduce the risk of
line entanglement and assist proper travel of pulley assembly.
Attach zipSTOP braking line to
redirection line with a quicklink and
recommended swivel, support pulley
9.10 Fitting Redirection Line
ONLY USE APPROVED TERMINATION METHODS FOR ALL ROPE CONNECTIONS
www.headrushtech.com
and sling
Brake Trolley
Double Line – 2:1 Redirection Ratio Example
|
+1-720-565-6885
Attach redirection
pulley to
overhead line
43
Advertisement
Table of Contents
