Table of Contents
Advertisement
9.6 Fitting zipSTOP Brake Unit
The zipSTOP Brake Unit may be mounted horizontally or vertically. The mounting bracket is designed for use
with a flat or curved surface. Curved surfaces must have a minimum 150 mm (6") diameter.
ONLY INSTALL THE ZIPSTOP BRAKE UNIT ORIENTED DIRECTLY INLINE WITH THE TYPE 1 PULLEY
The Braking Line feeds straight out of the device, without twist, and centered within the Nozzle. Accelerat-
ed Braking Line wear may occur if the line bears onto the Nozzle edge.
DO NOT REUSE SELF-LOCKING NUTS
Always use new nuts, as reuse of self-locking nuts may compromise connection integrity. This type of nut
is used on the Brake Trolleys.
Fit the zipSTOP Brake Unit as follows:
INSTALLATION NOTES
Always orient the zipSTOP Brake Unit directly in line with Type I Pulley.
Always use through bolts with large washers and self locking nuts.
It is recommended that double helix spring washers are located under mounting nuts to allow for movement in
primary mount point when used on a wooden structure or use split ring washer or comparable with a rigid structure
to reduce risk of loosening due to vibration
Always mount the zipSTOP Brake Unit a sufficient distance from the zip line so that Redirection Lines and pulleys do
not interfere with rider.
Once installation is complete ensure the zipSTOP Braking Line is not twisted and feeds linearly through the Nozzle.
Install the rubber RattleStop bumper
Install the RattleStop pin
www.headrushtech.com
INSTALL THE RATTLESTOP
|
+1-720-565-6885
37
Advertisement
Table of Contents
