Connecting The Headphones; Setting The Basic Functions; Switching On The Device For The First Time; Standby Mode - Sonoro sonoroSTEREO 2 Operating Manual

5.
Connect a lamp to the socket on your sonoro-
LIGHT.
7.7

Connecting the headphones

Headphones with a 3.5 mm jack plug (not supplied)
can be connected to the device.
L WARNING!
Risk of injury if headphones are used incorrectly!
Incorrect use of headphones can cause severe
accidents and damage your health.
– When you are using the headphones, do not
set an excessively high volume.
1. Turn the click wheel to the left to set the volume
to minimum.
2. Insert the headphone jack plug into the port on
the back of the device.
3. Slowly turn the click wheel to the right to
increase the volume.

8 Setting the basic functions

The individual menus let you select the functions and
settings of the device.
8.1 Switching on the device for the first
time
After you have switched the device on for the first
time, the LCD display shows the clock display and the
[Tune to FM RDS station to set time & date] message.
i
In FM/DAB mode, the time and date are set auto‐
matically unless this function has been disabled.
8.2

Standby mode

The following settings can be configured in
the Standby mode:
 Setting the time manually.
 Setting the date manually.
 Switch the date on the display on/off.
The procedure to set the individual functions is the
same.
Setting the time manually
Fig. 11: Setting the time manually
94
1.
In Standby mode, press the [SETUP] button on
the device or the remote control.
 The display shows the [Set Time] menu
(Fig. 11).
2.
Press the click wheel to set the hours.
 The hour display will flash.
3.
Turn the click wheel to set the hours.
4. Press the click wheel to confirm the setting.
 The minute display will flash.
5. Turn the click wheel to set the minutes.
6. Press the click wheel to confirm the setting.
 The time is set.
i
Use the [Next] and [Previous] buttons to
toggle between the hours and minutes
display.
i
After 10 seconds of inactivity, the device automat‐
ically switches to Standby mode without saving
the settings.
Setting the date manually
Fig. 12: Setting the date
1. In Standby mode, press the [SETUP] button on
the device or the remote control.
 The display shows the [Set Time] menu
(Fig. 11).
2.
Turn the click wheel until [Set Date] is shown.
3. Press the click wheel.
 Now you can set the date by rotating the
click wheel.
i
You can switch between the day, month
and year display by pressing the click
wheel.