Programming Options; Power Saver Mode - Avital G5103 Owner's Manual

still be in Valet Mode. This applies to all states of the system
including arm, disarm, and Valet Mode.

Power saver mode

Your system will automatically enter Power Saver Mode while
armed or in Valet Mode, after a period of time in which no oper-
ation has been performed. This lowers the current draw on the
vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
➤ Power Saver in Valet Mode: When the system enters Valet
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet Mode, the LED will shut off. If the system
remains in Valet Mode, the LED will come back on the next
time the ignition is turned on and then back off.

Programming options

Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some
may require installation labor.
30 © 2008 Directed Electronics—All rights reser ved