Silent Mode - Avital G5103 Owner's Manual

and know where the Valet
with your installer at the time of installation for both the location
and the preset response (1-5 presses) of the Valet
Location of Valet Button_________________________________
Number of Presses_____________________________________
Important! The Valet button can be programmed to
respond to 1-5 presses for the disarm function. You must
check with the installer to verify the programming for
your individual unit.
➜

Silent mode

To temporarily turn off the arm or disarm chirps, use Silent
Mode™. Simply press
arming or disarming, and the confirmation chirp(s) will be elim-
inated for that one operation only. If you want the arm/disarm
chirps turned off permanently, your dealer can do this for you.
16
®
To disarm the security system,
turn the ignition to the ON posi-
tion. Press the Valet button the
preset number of times (one to
five times) within 15 seconds.
After five seconds, the system will
disarm. If the system does not
disarm, you may have waited too
long; turn the ignition off and on
and try again.
switch is located. Be sure to check
for less than one second before
© 2008 Directed Electronics—All rights reser ved
switch.
®
DRW-35